User's Manual
Receiver model: WH2642
Sensor model: WH22B
Version 1.0 Page 2
1. Introduction
Thank you for your purchase of the Weather WH2642 Wireless Internet Remote Monitoring Weather
Station. The following user guide provides step by step instructions for installation, operation and
troubleshooting.
2. Quick Start Guide
Although the manual is comprehensive, much of the information contained may be intuitive. In
addition, the manual does not flow properly because the sections are organized by components.
The following Quick Start Guide provides only the necessary steps to install, operate the weather
station, and upload to the internet, along with references to the pertinent sections.
Required
Step
Description
Section
1
Assemble and power up the sensor array
3.3
2
Power up the outdoor thermo-hygrometer sensor
3.4
3
Power up the indoor thermometer-hygrometer-barometer sensor
3.6
4
Power up the ObserverIP, connect to your router and synchronize with the
indoor and outdoor sensors
3.8
5
Calibrate the relative pressure to sea-level conditions (local airport) on the
ObserverIP module
3.11.6.1
6
Register and upload to Weather Underground Weather Server
3.10
3. Getting Started
The WS-0900-IP weather station consists of an ObserverIP receiver, the sensor array, the outdoor
thermo-hygrometer sensor, and the indoor wireless thermo-hygrometer-barometer.