User Manual

Version 1.0 Page 2
LCD Segment Height: 0.75 inch
1
Thermometer transmitter (WH19)
Dimensions (LxHxW): 2.75” x 1.75” x 0.75”
1
User Manual
2.2 Recommend Tools
Hammer for hanging remote thermometer transmitter.
2.3 Thermometer Sensor Set Up
Note: Do not use rechargeable batteries. They tend to have a lower operating voltage, do not have
a wide temperature range, and do not last as long as non-rechargeable batteries.
We recommend fresh alkaline batteries for outdoor temperature ranges between -4 °F and 140 °F and
fresh lithium batteries for outdoor temperature ranges between -40 °F and 140 °F .
1. Remove the battery door on the back of the sensor by sliding the compartment door down, as
shown in Figure 1 .
Figure 1
1
Integrated hanger for zip tie
2
Wireless transmitter LED
3
AA Battery
4
Battery Compartment Cover
2. Insert one AA battery.
3. After inserting the battery, the remote sensor LED indicator will light for 4 seconds, and then
flash once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting data.
4. Close the battery door.
2.4 Display Console Set Up
1. Move the remote thermometer(s) about 5 to 10’ away from the display console (if the sensor
is too close, it may not be received by the display console).
2. Remove the battery door on the back of the display, as shown in Figure 2. Insert one AA
(alkaline or lithium, avoid rechargeable) battery in the back of the display console.