Installation & Assembly

F O R A LIFE O F S T YLE
TM
206 wembly Road.
New Windsor, NY 12553
Phone: [phone]
Fax: [phone]
info@nextures.com
www.nextures.com
1. Remove the T-valve,lock nut and
washer from the spout body. Place
spout in center hole of sink. Assembly
washer and tighten the lock nut to it.
Connect the T-valve to the spout body
using the wrench .
2. Remove mounting hardware from
handle body. Connect water supply
tube to valve body and tighten with
lock nut. Do not allow the water
supply brass tube to twist. Use two
wrenches, as shown in the diagram,
tighten the flexible hose.
3. Place the spout in center hole of
sink and handle body through right
hole.
(Left is red, right is blue). Assemble
the rubber washer,washer and tighten
with lock nut.
SINGLE-HANDLE LAVATORY FAUCET
INSTALLATION INSTRUCTION
4. Connect handle body and faucet
body with braided hoses. Tighten
wrench tight.
5. Screw and tighten the flexible hose
to the faucet.Left is red, right is blue.
Do not allow the water supply brass
tube to twist.
6. Attach flexible hose to water
supply.