Instructions/Assembly Guide

Assembly Instructions
6
1. Place the Double Plastic Caps (12) on the Central Rail (9) as shown below.
2. Lay the Slats (11) in two rows across the base of the bed. The slats must be
convex side up with the ribbon on the underside. The assembly hole on the slat
end must be on the outside position. Next, insert the end of the slat into the
Plastic Cap (12).
3. Place the Plastic Pin (K) on the slats to the Side Rail (7) and (8) as shown
below.
King Bed
(12)
(9)
(9)
(12)
(12)
(12)
(11)
(12)
(11)
(K)
(11)
11