Manualshelf

User's Manual

ManualsBrandsFimi ManualsElectronicsWEB PAD
21222324252627282930
23
WT121
9.1.0 POWER SUPPLY
TherearetwosourcesofpowerforProScribeoperation:thebatteryandtheACadapter.
9.1.1 AC
YoumayoperateyourProScribewithACpowerintwodifferentways.MountedintheDockingstationWD121.., or
connecteddirectlytotheACadapterg.23a).TorunyourProScribeonthebasestation,placethepadintoandconnect
theACadaptertothejackattherearofthebasestation.ToplugtheproductdirectlytotheACadapter,locateandpluginto
the DC adapter at the lower right corner of the product.
(g.23a)
9.1.2 BATTERY
WhenusingtheProScribeforthersttime,itisadvisabletochargethebatteryforatleast2hours.
Aftertheinitialcharging,whennotinuse,theProScribetakesapproximatelythreehourstofullycharged;ittakes4hours
to fully charged while in use. Battery duration depends on the actual use of the device and may be affected by heavy-duty
application.
In most applications it is between two and three hours.
The power light on the top right indicates the level of battery charge.
Turn on the power to see the power light.
• Full charge The power light is solid green.
• Low chargeThepowerlightisblinkinggreenwhenthebattery’sremainingchargedfallstolessthan6percent.
• Critical low chargeThepowerlightblinksamberwhenthechargefallsunder3percent.
If your ProScribe is powered up and immediately enters the suspend mode, it means the battery is uncharged.
In order to optimize battery operation, open only the applications you are actually using.
Toconservebatterypower,disableWLANwhenit’snotinuse.
To change battery
• Switch OFF your ProScribe.
•UnlockIthebatterylatch1(ref.g.11b)
•Whileonehandholdsthebatterylatchtwointheunlockedposition,usetheotherhandtopullthebatteryoutoftheslot.
• Replace with another battery
NOTE:
Whenfullychargedandnotinuse,yourProScribehasalifeofoneweek.
CAUTION:
Switch OFF your ProScribe before removing or changing the battery pack.