User's Manual

25
ProScribe CV
12.0.0 TROUBLESHOOTING
12.1.1 THE ProScribe WILL NOT TURN ON...
• When power is on, you will see:
On the pad: Power indicator light above the screen on the right will turn green
 •Ifpowerison,butyoustilldon’tseeanythingonthescreen,wakeupthepadbytappingonthescreenorbypressing
control buttons located on the right hand side of the screen.
 •IfpaddoesnotpoweronattachtheACadaptertotheunitbyeither;
 PluggingtheACadapterintotheDCinthatistheD-SUB9input,makingsurethattheAdapterisalsopluggedintothe
 wallsocket.
• If the preceding steps do not turn the pad on, try restarting the machine:
 Asalastresortremovethepowercord,waittensecondstheninsertagainthepowercord,toswitchontheProScribeor
try to push the reset switch button located between the 2 USB ports.
12.2.1 MY SYSTEM DOES NOT RUN SMOOTHLY
Poor wireless signal quality or the simultaneous opening of too many applications will cause deterioration in application
performance.
To free up memory, close applications that are not in use.
 Checkwirelesssignalquality:
 •WLANLEDindicator.WhentheWLANLEDindicatorisblue,awirelesssignalisavailable.AblinkingLEDindicates
 aweakorunstablesignal.Whennosignalisavailable,theLEDisOFF.Ifsignalisweak,trymovingclosertoyour
 AccessPoint,ortryrepositioningtheantennaoftheaccesspoint.
 •Networkicon.DoubletaptheNetworkicononthebaratthebottomofthescreen.ChoosetheWirelessInformation
tab to show the current connection.
12.3.1 HOW DO I TURN OFF MY ProScribe
To end operation: Press the power switch on the upper right side.
 Ortapthe“START Menu”andthenchoose“Shut Down”toturnoffthepad.
NOTE:
 PressingthePowerswitchofthedeviceformorethenvesecondswillmakeanhardturnOffpreventingtheOperating
 Systemtoperformthecorrectshutdownprocedure.
12.4.1 WHEN I USE THE STYLUS PEN...
• System does not respond to taps…
a. Try tapping the center of an icon.
b. Re-calibrate the tapping pattern.
NOTE:
 Youmightneedtopracticeacoupleoftimeintooperateyourscreenwithtaps.
• The mouse arrow is out of alignment…
The mouse arrow does not point to the center of icon as you intend. It might be due to the viewing angle or the stylus
may require calibration.
 •Usersaccustomedtoamousedeviceusearightclickforquickaccesstocommandoptionsofanobject.
The stylus pen offers a similar command function. Here’s how: See parag. 7.2.1