Quick Installation Guide

FIMER_UNO-DM-COM KIT & UNO-DM-PLUS Ethernet COM KIT_Quick Installation Guide_EN_RevC
8
For more
information, contact
your local FIMER
representative or
visit:
fimer.com
The company reserves the right to
make technical changes or to modify
the content of this document without
prior notice. With reference to purchase
orders, the agreed clauses prevail.
FIMER assumes no responsibility
whatsoever for potential errors or
information gaps in this document.
All rights in this document, in the content
and illustrations shown are reserved.
Any reproduction, transmission to third
parties or use of the contents, partial or
complete, without the written consent of
FIMER is prohibited.
Copyright© 2021 FIMER.
All rights reserved.
26-04-2021
9. Features and Technical Data
Connections
Type of connectors
Connectors with spring
(Cables accepted: 0.2-1.5 mm² / 24-16 AWG)
Ethernet 10/100Mbits base –T (only on UNO-DM-
PLUS Ethernet COM KIT)
Alarm relay rating Floating contact (230V, 1A max.)
Remote On/Off Digital input
Serial communication protocol
ModBus RTU Sunspec compliant or Aurora
Protocol
Safety
Brands CE
Class of insulation I
EMC and safety standards EN 60950-1; EN 55022 ; EN 55024
READ THE MANUAL – E In case of inverter fault, remove and keep any accessory boards installed
inside the inverter before shipping it to FIMER. Any accessory board will not be reinstalled in case of
inverter replacement.