Instructions / Assembly

PG 6
PG 6
• “Fan out” wires as illustrated with 3M-22 below the wall opening.
As in the example: fan out the wires so that the C wire is above the C
terminal, the W above the W. This allows the 3M-22 to t snugly to the
wall.
Caution
Do not allow wires to touch each other or parts on thermostat.
• Wires will position behind the 3M-22 and up over the
terminal area.
• Do not bunch wires behind the 3M-22. Feed any slack
back into the wall opening.
Connect Your Wires
• Connect labeled wires only to a terminal with the same letter label.
• Insert the wire in the terminal well and tighten the screw securely.
NOTE: If you wish you can mount the 3M-22 to the wall rst, and then connect the wires.
• The 3M-22 can be externally powered with a power source rated from 12V to 24V, AC or DC, at
300ma or greater. If used, connect to the C and RH terminals (no polarity).
P
R
O
G
R
A
M
S
E
T
C
L
O
C
K
S
E
T
D
AY
F
I
LT
E
R
C
A
L
IB
S
W
IN
G
H
O
L
D
HVA
C
C
O
P
Y
M
T
W
F
C
TARGET
TEM
P
H
E
AT
LINK
R
A
D
I
O
F
C
B
O
W
W
2
Y
Y2
R
H
R
C
G
A
From HVAC system
RH
Y
G
C
W