Specification

There is a conduit connector knock-out located on the lower side of

the monitor housing.

What voltage is acceptable to power the FILTERSCAN WiFi Air Filter

Monitor via the conduit?

Typically 24V AC/DC, although an input voltage as low as 15V DC is

acceptable.

Model FS-245-B Do I have to install batteries if I power the Monitor from the optional AC

Adapter?

No.

Can I utilize both the AC Adapter and batteries for backup?

Yes, you can install batteries even though you also have an AC

adapter installed. Such power backup is unnecessary however

because the monitor’s non-volatile memory stores all operating

parameters in the event of a power failure.

Wireless Router What should I do if I am unable to connect my monitor to my wireless

router?

1. If you are pairing your monitor with your router using WPS, make

sure that WPS is enabled on the router by trying to connect

another wireless device to the router using WPS (some routers

have this function disabled), or contact your router supplier.

2. If you are using manual pairing, make sure that you have the

correct password.

3. Make sure you monitor is within range of your wireless router. If

not, you may have to relocate your router.

4. Determine your routers wireless security network type.

Supported network types are:

 WEP128

 WPA-PSK (TKIP)

 WPA2-PSK (AES)

 WPA-PSK mixed mode (some access points, not all are

supported)

To do this, you will need to consult your routers manual. If your

routers wireless security has been set to any other method, you

will need to change it to one of the above, preferably WPA-PSK

(TKIP) or WPA2-PSK (AES).

5. Make sure network SSID Name and password conform to this

chart:

Special Character Permissions in

Network Name (SSID) & Password

Character

SSID /

Network Name

Password

space

Yes

(

Yes