Specification

4. Using your iPhone or iPad, go to the Settings app and connect to the FILTERSCAN network. It may

take a few minutes for the FILTERSCAN network to appear.

5. Once the iPhone or iPad is connected to the FILTERSCAN network, open a web browser.

6. Enter the IP address 192.168.1.1 in the URL box

Figure 13: FILTERSCAN WiFi Network Configuration Page

7. Wait for the page to update and show the available networks. This may take several minutes. You are

looking for the SSID of your router. If the expected network is not listed, press the Refresh button

(you may need to do this several times). If it still does not appear, check that the router is on and has

an Internet connection.

Figure 14: FILTERSCAN WiFi Network Configuration Page

8. Enter your router’s password (see acceptable Special Character chart in FAQ section) and press

the Join Network button. If the pairing was successful, the amber light on the FILTERSCAN unit will

flash quickly for a few seconds and then go out. If it is still flashing slowly, then it did not pair with the

router.

9. If the pairing fails, check that you are using the correct password: On your iPhone, open up Settings

and Select WiFi. Connect the phone to the router. Then press the “information” icon to the right of the

router’s SSID (and “i” inside a circle). On the new page select “Forget this Network”. This will sever

your connection and send you back to the WiFi page. Now select the router SSID. You will be asked

to type in the password. If it is correct, you will connect. Now go back to repeat the above instructions

starting at Step 4. If this fails, call the CleanAlert helpline: 888-414-3569, extension “2”.

Supported network types for Manual pairing:

 WEP128

 WPA-PSK (TKIP)

 WPA2-PSK (AES)

 WPA-PSK mixed mode (some access points, not all are supported)

Refresh

Join Network

Loading Pre-scanned Networks