Installation guide

14
WiFi Status LED Blink Indication Notes
WiFi Flashing
WiFi set to factory
defaults
Continuous slow Yellow
flashing
Connect to FILTERSCAN WiFi
network and configure the
FilterScan device.
Downloading firmware
update file
Continuous Fast Yellow
Flashing
No action required
Connecting to server Fast Green Flashing No action required
C onnect to a W ireless R outer “W ithout ” a WPS B utton
Follow these steps if your wireless router DOES NOT have a WPS button. This is referred to Ad Hoc
Association.
1. Items needed:
a. A WiFi-enabled device with web browsing capabilities, such as a laptop, smartphone, or tablet
b. The wireless password or passphrase for your router
c. The SSID of your wireless router (look on the side or bottom of the router or consult its
manual)
2. Reference Figure 12 to locate the FILTERSCAN WiFi Air Filter Monitor WPS button.
3. Depress and hold the WPS button until the WiFi Status Indicator blinks green then fast red. This may
take up to 30 seconds. Release the button and wait until the WiFi Status Indicator blinks amber.
4. Using your WiFi-enabled device, connect to the “FILTERSCAN” network. On an iPhone or iPad you
do this by going to the Settings app. It may take a few minutes for the FILTERSCAN network to
appear.
5. Once the WiFi-enabled device is connected to the FILTERSCAN network, open a web browser on
your WiFi-enabled device.
6. Enter the IP address 192.168.1.1 in the URL box
Figure 13: FILTERSCAN WiFi Network Configuration Page
7. Wait for the page to update and show the available networks. You are looking for the SSID of your
router. This may take several minutes. If the expected network is not available, press the “Refresh”
button.
Figure 14: FILTERSCAN WiFi Network Configuration Page
8. Enter your router’s password and press the Join Network button.
Supported network types for ad hoc association:
• WEP128
• WPA-PSK (TKIP)
• WPA2-PSK (AES)
• WPA-PSK mixed mode (some access points, not all are supported)
Refresh Join Network
Loading Pre-scanned Networks