Installation Guide

12
your wireless router communicate with each other and establish a connection with no further action
needed.
NOTE: If you will be using a corporate network to connect the monitor to the Internet, contact your
network administrator prior to enabling the “Manual Pairing” steps in the Connecting to a
Wireless Router Without a WPS Button section. Company policy may prohibit the use of
web servers for security reasons. CleanAlert is not responsible for the use of, nor makes
any claims as to the security of the web server interface over your network. The use of the
web server is the responsibility of the end user.
5. Go to “Connect to the AirFilterSentry Notification System Server” later in this manual.
Table 1 WiFi Trouble-shooting Guide Locate the internal WiFi Status Indicator above. (The
Heartbeat and other normal, non-WiFi status indications which appear on the STATUS
LED are shown elsewhere in this manual.)
LED Blink Indication
WiFi Status
Notes
None
Normal operation
Flashes Red 1 time,
pattern repeats 3 times.
Cannot find any WiFi
device
Make sure wireless router is turned on
Flashes Red 2 times,
pattern repeats 3 times.
Error Connecting to WiFi
network after wireless
router configuration
Check to insure other devices (laptop or
mobile device) can connect to your
wireless network
Flashes Red 3 times,
pattern repeats 3 times.
Not paired with wireless
router
See the “Connect to a Wireless Router”
section and make sure wireless router is
turned on
Flashes Red 4 times,
pattern repeats 3 times.
Wireless router is off or not
found
Make sure wireless router is turned on
Flashes Red 5 times,
pattern repeats 3 times.
No Internet Connection
Check to insure the network cable to the
router is connected, and there is Internet
service
Flashes Red 6 times,
pattern repeats 3 times.
Server registration failed.
Serial number or MAC
address does not exist in
the AFS database.
Insure that the correct serial number and
MAC address of the monitor appear in the
“Edit Monitor” screen in your AFS account
Flashes Red 7 times,
pattern repeats 3 times
Unacceptable character in
SSID or Passphrase
See acceptable Special Character chart in
the FAQ section
Slow Green Flashing
Software is waking
No action required
Fast Green Flashing
Connecting to server
No action required
Fast Yellow Flashing
Sending Status data to
server
No action required
Fast Red Flashing
In process of resetting WiFi
No action required
Slow Yellow Flashing
The monitor is in the web
server mode (see “Connect
to a Wireless Router
without a WPS Button”, or
Software is updating
Complete the instructions in the “Connect
to a Wireless Router without a WPS
Button” section
No action required. Do not turn power off
to monitor or router!