8233 Respirator N100 Particulate User Instructions (Keep these instructions for reference) Distributed by: TM .
This respirator helps protect against certain particles. Misuse may result in sickness or death. For proper use, see supervisor, or User Instructions, or call 3M in U.S.A., 1-800-247-3941. In Canada, call Technical Service at 1-800-267-4414. IMPORTANT Before use, wearer must read and understand these User Instructions. Keep these instructions for reference. Use For Solids such as those from processing minerals, coal, iron ore, flour, and certain other substances.
2. Do not use when concentrations of contaminants are immediately dangerous to life and health, are unknown or when concentrations exceed 10 times the permissible exposure limit (PEL) or according to specific OSHA standards or applicable government regulations, whichever is lower. 3. Do not alter, abuse or misuse this respirator. 4. Do not use with beards or other facial hair or other conditions that prevent a good seal between the face and the sealing surface of the respirator. 5.
1. Thread the top elastic strap through the top buckle. Repeat for the bottom elastic strap. Place the bottom elastic strap around the head, just below the ears. Untwist the strap. 2. Pull the top strap over your head, resting it above the ears at the top back of your head. Untwist the strap. 3. Adjust the strap tension by pulling the straps as shown (3a). Strap tension may be decreased without removing respirator from the head by pushing out on the back of the buckle (3b). 4.
FOR MORE INFORMATION In United States, contact: Internet: www.3M.com/occsafety Technical Assistance: 1-800-243-4630 For other 3M products: 1-800-3M-HELPS or 1-651-737-6501 3M Occupational Health and Environmental Safety Division 3M Center, Building 235-2W-70 P.O. Box 33010 St. Paul, MN 55133-3010 ©3M 2004 Distributed by: TM .
