User Manual

5
pull that minimizes bends in the cable, otherwise excess cable friction or failure could
result.
Adding Tension to Hook Grasp
To add more force to the grasp of the hook, additional tension bands may be applied
using the E-Z Hook Tension Band Applier (55144) or similar device. Additional bands
are included with the hook and are available in beige (53869) or black (53869-BLK).
For greater tension, hook rings (57500) or stainless-steel tension springs (55363) may
be used. Tension springs are recommended for situations where chemical or heat
exposure could cause band or ring failure.
Compatibility
Fillauer hooks have been tested with and are recommended for use with Fillauer wrists
that have a ½-20 internal thread. They may be used with any equivalent ½-20 threaded
wrist units; however, damage caused by other manufacturers wrist units is not covered
under warranty of this device.
Only Fillauer tension bands, hook rings, and tension springs may be used with Fillauer
hooks to adjust the grasping force of the hook.
Disposal/ Waste Handling
The product must be disposed of in accordance with applicable local laws and
regulations. If the product has been exposed to bacteria or other infectious agents,
it must be disposed of in accordance with applicable laws and regulations for the
handling of contaminated material.
All metal components may be removed and recycled at the appropriate recycling
facility.
Warranty
This product has an 18-month warranty against manufacturer defects.