Manualshelf

Instructions / Assembly

ManualsBrandsFILL-RITE ManualsPlumbing12-Volt 8 GPM 1/6 HP Portable Fuel Transfer Pump (Pump Only)
12345678910
Inspect power cable before each use! Damage to the
outer jacket of the cable that exposes wiring requires
replacement of the power cable.
Install power cable by aligning at on plug with front of
pump. Insert the plug into the pump housing as shown.
Lock into place using the threaded collar (A). HAND
TIGHTEN ONLY! The power cable terminates in green,
black, and red clamps. All three clamps must be used.
1. The green (ground) clamp should be connected rst.
Connect the green clamp to the vehicle chassis or
earth ground. DO NOT connect the green clamp to the
negative power source post.
2. Next, connect the black (negative) clamp to the
negative post of the DC power source.
3. Connect the red (positive) clamp to the positive post
last.
Clamps should be disconnected in reverse order.
DC Power Connection
DANGER! Be certain the power switch is “OFF” prior to connecting the battery clamps / power cables to the
power source or installing the cable into the pump to prevent unexpected starting of the motor. Unexpected
motor start can cause unintended discharge of fuel, creating an explosion and re hazard.
6
Earth /
Chassis
Ground
Green
Red
Black
A
Flat
1
2
3
Flange Conguration
The inlet and outlet anges of your RD series pump can be congured vertically, horizontally, or a combination of both.
To change the position of a ange:
1. Remove the two socket head cap bolts holding the ange in position.
2. Remove the ange; examine the sealing surfaces to be certain they are clean and will seal properly.
3. Position the seal and screen, and place the ange in the desired position.
4. Use the two socket head cap bolts to reattach the ange rmly to the pump housing. Torque to 50 inch lbs. with a 4
mm hex key.
WARNING! Be certain seals and screen are properly positioned and clean any time the anges are
recongured. Improperly installed or dirty seals or screens could cause leaks and the potential for re or
explosion
Inlet Outlet
CAUTION! Always be certain the power switch is accessible after reconguring the inlet and outlet ports.