Instructions / Assembly

ManualsBrandsFILL-RITE ManualsPlumbing120-Volt 25 GPM 1/3 HP Continuous Duty Fuel Transfer Pump with Standard Accessories (Foot Mounted)

Table Of Contents

fillrite.com

| NX25-120 & NX25-240 SERIES AC FUEL TRANSFER PUMPS

INSTALLATION AND OPERATION MANUAL

This Troubleshooting Guide provides basic diagnostic assistance. If you have further questions, contact us at 1 (800) 720‑5192 (M‑F 8 AM–5 PM ET), or at fillrite.com.

Troubleshooting

Symptom Cause Solution

Pump will not prime

1. Suction line problem

Check suction line for leaks or restrictions; it may be too small in diameter, too long,

ornot air‑tight

2. Vanes sticking Check vanes for nicks, damage, obstructions, or excess wear; replace as necessary

3. Excessive rotor, vane, rotor cover, or housing wear Inspect rotor, vanes, rotor cover, and housing for excess wear; replace as necessary

4. Inlet / Outlet blocked Check pump, hose, nozzle, and filter / strainer for blockage

5. Excessive vertical or horizontal inlet plumbing Reduce vertical or horizontal distance from pump to liquid

6. Bypass valve stuck Open valve, remove debris

Low capacity

1. Excessive dirt in screen Remove and clean screen

2. Suction line problem

Check suction line for leaks or restrictions; it may be too small in diameter, too long, not

air‑tight, or too low vertically

3. Excessive rotor, vane, rotor cover, or housing wear Inspect rotor, vanes, rotor cover, and housing for excess wear; replace as necessary

4. Hose or nozzle damage Replace hose or nozzle

5. Low fluid level Refill tank

6. Clogged outlet filter Replace filter

Pump runs slowly

1. Pump in bypass Normal operation; pump naturally reduces speed in bypass mode

2. Vanes sticking Check vanes for nicks, damage, obstructions, or excess wear; replace as necessary

3. Motor problem* Refer to Warranty Policy

4. Excessive outlet restrictions Reduce outlet restrictions (e.g. use shorter hose, remove swivel)

Motor stalls / breaker trips

1. Short in wiring Inspect electrical wiring for shorts and replace as necessary

2. Excess rotor or vane wear Check vanes for nicks, damage, obstructions, or excess wear; replace as necessary

3. Pump rotor lock‑up* Clean and inspect rotor and vanes; replace as necessary

4. Debris in pump cavity Clean debris from pump cavity

Bold text indicates repairs that are not serviceable by the owner; please refer to our Warranty Policy on page 2 for further instructions.

*This condition will shut the motor off.

DO NOT open or attempt to repair the motor on your NX25‑120 or NX25‑240 series pump. Opening the motor case can compromise the integrity

of theExplosion Proof construction and will void any existing warranty and certification (UL listing). Please refer to the Warranty Policy

located on page 2.

WARNING

DANGER

Disconnect all power prior to performing any service or maintenance. Failure to disconnect the power may cause electrical shock, or unexpected

starting of the motor, resulting in injury or death.