Instructions / Assembly

IMPORTANT! When the meter is in the “Deep Sleep” mode, dispensing uid will
NOT turn the meter on. The meter will not display or accumulate any uid that is
dispensed while in “Deep Sleep” mode.
• Pressing any button will turn the meter
on when in deep sleep mode (uid ow
will not turn the unit on or cause it to exit
deep sleep mode).
• The last count and selected totalizer is
retained and displayed when the meter
is turned on.
• Pressing and releasing the TOTAL
button will switch between the resettable
and non-resettable totalizers. (The “R”
icon will be displayed when the
resettable total is displayed).
• Pressing and holding the RESET button
for 2 seconds will reset the counter.
• Pressing and holding the RESET button
and TOTAL buttons for 2 seconds will
reset the totalizer. The resettable totalizer must be active in order to reset it.
• Pressing and holding the RESET button and CAL buttons for 2 seconds will display the
software version for 2 seconds and then perform a segment check for 3 seconds, and
then restore the display.
• Pressing and holding the CAL button for 5 seconds will place the meter into a deep sleep
mode.
IMPORTANT! “Deep Sleep” mode is designed to maintain a status of operational
readiness while offering battery conservation. The meter should be placed in this
mode under the following circumstances:
• Flushing the unit so the dispensed volume is not counted.
• Traveling over rough surfaces (off-road); uid in the metering chamber will be
counted if uid is being jostled.
• Extending battery life; the meter can be placed in deep sleep mode repeatedly
with no adverse effect on battery life.
• After 30 seconds of inactivity, the display will blank to conserve battery power.
• If the meter is connected to the external power source, the display will not blank unless
forced into deep sleep mode.
• If external power is removed, the meter will automatically switch to battery only operation
and vice-versa.
• The counter and resettable totalizer 2 can be reset even if uid ow is detected. The
meter will continue counting during the 2 second RESET button press, reset to 0, and
resume counting.
Low Battery Warning
The digital display includes a “Low Battery”
warning indicator. When the batteries
reaches a level low enough to require
replacement, the display will show “BAT”
as a reminder to change them. Replace
batteries when indicated per procedure on
page 8.
6