User Manual

Image Broadway 6 Help
Paths > Path Creation
Path Creation
Click on the Path tool on the Toolbar as shown below.1.
Select Add/Edit from the Path Options Toolbar as shown below.2.
Click on the screen to create an anchor point, and move the mouse to the next point and click on the screen again to
create the next anchor point. There is a straight line connected between these two points. Continue the steps to
create more anchor points. See the example below for three anchor points.
3.
Click on Point #2 and two symmetric opposite directional points with handles will show up. You can drag one of the
handles to create the curve you like. These two points are moving together in opposite directions. To move only one
directional point, press the Shift key.
Press and hold the CTRL key to move the anchor point.
Press and hold the Alt key to move the whole path.
Press and hold the Esc key to delete the anchor point.
4.
Select the Move Pt in the Path Tool Options toolbar. Click on any anchor point and drag it to the location that you
want.
5.
Select Move All in the Path Tool Options toolbar. Click anywhere and drag the whole path to the new location.6.
Select Delete in the Path Tool Options toolbar. Click the anchor point to delete it. To remove the entire path, press
the Shift key when click on any anchor point to delete it.
7.
Click on Start point again to close the path. You don't have to close it if you don't want to convert it to a selection.8.
Once a path is closed, you may continue to add more segments to the current path by repeating the steps above. You9.