User Manual

Image Broadway 6 Help

Brush and Retouching > Retouching Tools > Clone Tool

Clone Tool

Select the Clone tool.1.

Select a brush from the Brush/Mask toolbox.2.

Click the down arrow on the blending Mode and select a blending mode in Brush/Mask toolbox.3.

Select the Opacity from 0-100 in Brush/Mask toolbox. Lower value gives transparent effect; higher value gives

more opaque painting.

Check off the Align option if you want to align the source point with the first target point. Any further stroke will

always continue from the first target point as the offset point. When the Align option is off, each stroke sets a

new first target point.

Click on the image and hold down Control key for the source point.6.

Click and drag on the image to clone.7.

Click on the image and hold down the Control key again to change the source point.8.

Click two points with Shift key down to clone a line.9.

Click on the icon for the menu to Reset or Reset All options.10.

For example, click on the bike (see picture labeled Source). Check off Align option, and paint two strokes, the second

stroke is different from the first stroke (see pictured labeled Align on). You can use this option for duplicate one

section to another section. If you turn off Align, the second stroke is identical to the first stroke (see picture labeled

Align off). You can use this option to repair by using the same source.

Source

Align On

Align Off

Ctrl + Click