Instructions / Assembly

9
Figure 14
Figure 15
Insert the 3 volt battery (included) and make
sure the battery is properly seated with the
Positive + sign facing up. (Fig. 14)
Your DC motor is equipped with an auto learning
type of remote control. There are no frequency
switches on the receiver unit, the receiver will
automatically learn the frequency from the
remote control during the pairing process.
The remote control unit has frequency settings
that can be changed. The frequency settings on
the remote control should only be changed if
your fan experiences interference or if a second
or more fans with the same type of control
system are installed in the same structure.
(Fig. 14)
ON / DIM Switch: The ON position is to be used
for a light kit with CFL bulbs, the DIM position is
to be used for all other dimmable style bulbs.
(Fig. 14)
11. OPERATING
INSTRUCTIONS
Restore power to ceiling fan and test for
proper operation. (Fig. 15)
A. button:
Increase fan speed ( 6 speed max.)
B. button:
Decrease fan speed (1 speed minimal)
C. 6 SPEED LED indicators:
Pressing and holding the + button will
increase the fan speed automatically through
the speed settings and the increments
will be denoted on the LED indicators.
= minimum speed
= low speed
= medium low speed
= medium speed
= medium high speed
= high speed
D. button:
Maximum (6 speed).
E. fan off/set buton:
This button turns the fan off.
F. The " " button is used to set the fan
forward or reverse, press the button
forward (for warm weather) or reverse (for
cool weather).
G. button:
This button controls the light. Press and
release the button to turn the light ON or
OFF. Press and hold the button to set
the desired brightness. The light key has
an auto-resume, it will stay at the same
brightness as the last time it was turned
off.
ON
DIM
ON
DIM
ON ECE
1234
ON ECE
1234
Frequency Switch
Push support to
open the back cover
Code switch