Manualshelf

Installation Guide

ManualsBrandsFilament Design ManualsLighting2.5 in. Black Recessed Trim
12
\
1. Drill 5/8” (16mm) hole for wire. 1 Drill 2 5/8” (67mm) hole in mounting surface.
2. Feed wire through hole in mounting surface. 2. Remove distance ring and feed wire through hole.
3. Attach mini-pot with long screws included. 3. Attach mini-pot to surface using short screws
Some application may require pre-drilling. Use provided. Some application may require
1/16 drill for pilot hole. pre-drilling. Use 1/16 drill for pilot holes.
4. T5 wedge base XENON – 18 Watt bulb is included 4. T5 wedge base XENON – 18 Watt bulb is
with your mini-pot light. included with your mini-pot light.
5. Install bulb cover – turn-clockwise to lock into 5. Install bulb cover – turn-clockwise to lock into
position. position.
6. Connect to approved 12 Volt, 6. Connect to CSA approved 12 Volt, Class 2
Class 2 power source. This is provided when power source. This is provided when you
you purchase your DAINOSTARS in a kit purchase your DAINOSTARS in a kit format.
format.
WARNING: Risk of fire or electric shock. This product to be installed by a qualified electrician only.”
XENO-89
INSTALLATION INSTRUCTIONS
IMPORTANT NOTICE
SPACING
• Do not install less then 12” (30cm) on
center.
• When recessed mounting, leave min.
½” (1.27cm) air space over top of
fixture and between mounting board
and surface being fixed to whatever is
greater. Provide unimpeded air
space over top of fixture within a 5” x
5” area.
• When using in shelving unit or cabinet,
DAINOSTARS must be at least 10”
(25cm) from 1
st
. shelf surface. Also
make sure that any object on this shelf
is at least 10” (25mm) from light.
TRANSFORMERS
• When purchasing DAINOSTARS in a
kit the appropriate transformer is
included. Each O/P line on 100 & 150
Watt transformers must not exceed 50
Watts. Overloading a line will blow
your transformer.
• The 60-Watt transformer is designed
for 60 Watt draw on the O/P line.
• When making primary feed to
transformer case, make sure 120V
connections remain in the immediate
area of the entry hole. The tranformer
itself acts as a barrier between the
input line and the 12V O/P line.
Ma
y
30, 2007

Summary of content (2 pages)