Instructions / Assembly

OPTIONAL
COMMERCIAL
(FA-26 75)
120V
OPTIONAL
FOR ALL
FIXTURES
(FA-03-LG)
PL-18AL-14
OPTIONAL
COMMERCIAL
(FA-25)
PL-16
OPTIONAL
TELESCOPIC
(FA-01)
AL-04
120V
FA-22-BLT
FA-24
FA-22-CST-BLT
FA-24-LG-CST FA-24-LG
STANDARD
FOR ALL FIXTURES
(FA-03)
AL-17
OPTIONAL
FOR ALL FIXTURES
(FA-04)
AL-01
OPTIONAL
CONCRETE
ANY STAKE
PL-17
1. Thread mounting device onto base of xture. If using FA-03-LG or FA-04,
press into ground and connect to main cable. We recommend using our
FA-05 Quick Connector. If FA-01, make sure the base PVC is free of dirt to
allow the inner tube to be adjusted as needed. A set screw is provided to
set desired height. If using FA-25, you must dig a 6"-8" diameter hole, 10"-
14" deep. Loop main cable to stake or run xture wire out of the bottom to
the main cable. Make connection with FA-05 then back ll hole and wiring.
If using FA-22, -24 or -24-LG canopies, secure with appropriate screws for
mounting surface.
2. All 12v Area/Path lights are supplied with lamps installed. To remove
single contact lamps; turn o power, let cool down, push and turn counter
clockwise, then pull outward and away from socket. It is recommended
to lubricate lamp screw shell (not lamp contact) with dielectric or lithium
grease for ease of service and future maintenance. For T-3 Bi-Pin Halogen
and Xenon lamps; turn power o, let cool down, pull outward and away
from socket.
For Questions Call 1-888-882-1350
NOTE: All mounting stakes can be pressed or hammered into the ground with
a standard hammer or rubber mallet. We recommend our Focus FT-01 stake
installation tool (see below). Always leave the top 1" section of the stake above
ground to help isolate the metal from potentially corrosive soils. Fixture wire (18/2)
should be buried underground to prevent detachment. For a more permanent
mount, you can set the stake in concrete or use our FA-25 Commercial mounting
pedestal.
F
INSTALLATION INSTRUCTIONS FOR
ALL 12 VOLT AREA & PATH LIGHT FIXTURES
INSPECTED BY:
FT-01
FT-01
Stake Installation Tool
FT-01
Stake Installation Tool
If using FA-05 Quick Connector power must be on
Mounting Canopies
IMPORTANT SAFETY INSTRUCTIONS TO REDUCE THE RISK OF FIRE AND INJURY TO PERSONS:
1. Lamp gets hot quickly; turn o, unplug/disconnect and allow to cool down
before replacing the light bulb.
2. DO NOT touch hot lens, guard or enclosure.
3. DO NOT look into lamp when on.
4. Keep lamp away from materials that may burn.
5. Use only with wattage/lamp marked on xture warning and instructions.
6. Use the right light bulb base with the right socket.
7. DO NOT touch lamp at anytime. Use a lint-free cloth when handling the
Halogen light bulbs as oil from skin may damage lamp and shorten lamp life.
8. DO NOT operate xture with missing or damaged shield or lens.
FA-05
QUICK CONNECTOR
12/2, 10/2, 8/2
Focus
Transformer
12v Install AL/PL General 112211