Operating Instructions

This mobile phone meets the government’s requirements for exposure to radio waves. This phone is designed and manufactured not to
exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S.
Government. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate,
or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating positions accepted by the
FCC with the phone transmitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well
below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power
required to reach the network .In general, the closer you are to a wireless base station, the lower the power output.
The highest SAR value for the model phone as reported to the FCC when tested for use at the ear is 1.17 W/kg and when worn on the
body, as described in this user guide, is 1.40 W/kg (Body-worn measurements differ among phone models, depending upon available
accessories and FCC requirements.)
While there may be differences between the SAR levels of various phones and at various positions, they all meet the government
requirement.
The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the
FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant
section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: RYQEC1002
For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains
no metal and positions the handset a minimum of 1.5 cm from the body. Use of other accessories may not ensure compliance with FCC
RF exposure guidelines. If you do not use a body-worn accessory and are not holding the phone at the ear, position the handset a
minimum of 1.5 cm from your body when the phone is switched on.
The Device has an electronic label to access FCC ID. To access it, select: Settings->About Phone->FCC ID.
Hearing Aid Compatibility
(HAC) for Wireless Telecommunication Devices
This phone has a HAC rating of M4/T4.
What is hearing aid compatibility?
The Federal Communications Commission has implemented rules and a rating system designed to enable people who wear hearing aids
to more effectively use these wireless telecommunications devices. The standard for compatibility of digital wireless phones with
hearing aids is set forth in American National Standard Institute (ANSI) standard C63.19.There are two sets of ANSI standards with
ratings from one to four (four being the best rating): an “M” rating for reduced interference making it easier to hear conversations on the
phone when using the hearing aid microphone, and a “T” rating that enables the phone to be used with hearing aids operating in the
tele-coil mode, thus reducing unwanted background noise.
How will I know which wireless phones are hearing aid compatible?
The Hearing Aid Compatibility rating is displayed on the wireless phone box. A phone is considered Hearing Aid Compatible for
acoustic coupling (microphone mode) if it has an “M3” or “M4” rating. A digital wireless phone is considered Hearing Aid Compatible