Instructions / Assembly

2 / 2

28/9/2018

4. Fasten the white fixture lead wire to the white wire in the outlet box.

Fasten the wires together with an approved fastener (wire nut).

Starting about 1” below the fastener, tightly wrap the connection

With electrical tape so that the connection seals the end of the fastener.

WARNING

Make sure that there is no exposed wire or strands that

could cause a dangerous short circuit!

5. Connect the black fixture lead wire to the black wire in the outlet box.

Fasten the joined wires as in step 4.

6. Using the set screw and sealing washers,

Fasten the fixture back plate to the

outlet box.

7. Install the glass shade on the fixture with the socket ring.

8. Install the lamps (light bulbs).

NOTE: This fixture is rated for Max 60 watt type A lamp.

WARNING

DO NOT EXCEED RECOMMENDED WATTAGE!

9. Restore power to circuit at breaker or fuse box.

electrical tape

approved fastener

(

wire nut

)

Cup

Back plate

Set Screw

Mounting bar

Cup

Green screw

Tube

Drophead

lampshade