Instructions / Assembly

2
/
2
11/28/2018
Starting about 1” below the fastener, tightly wrap the connection
With electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit!
5. Connect the black fixture lead wire to the black wire in the outlet box.
Fasten the joined wires as in step 4.
6. Using the two ball nuts to fasten the fixture back plate to the outlet box.
7. Put the glass lamp shade into the cage and fix it with a metal clip.
8. Install the lamps (light bulbs).
NOTE: This fixture is rated for 60 watt type B, BA, C or CA lamps
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
9. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(wire nut)
Outlet box
Green screw
Long screw
Mounting bar
Ball nut
Glass shade
Roof
Light bulb
Metal clip
Cage