Instructions / Assembly
2 / 2
10/1/2018
4. Fasten the
ridded clear
fixture lead wire to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut).
Starting about 1” below the fastener, tightly wrap the connection
With electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit!
5. Connect the smooth clear fixture lead wire to the black wire in the outlet box.
Fasten the joined wires as in step 4.
6. Attach fixture pipe to fixture body and tighten screwed.
Attach the mouting plate to the junction box(not included) with the two outlex
box screws provided,fasten collar loop to nipple,secured canopy using outer ring.
9. Install bulbs to socket
NOTE: Use three 60-watt max, candelabra-base type CA-10 bulbs not included.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
.10 Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)
7.
8. Attach fixture pipe to fixture body and tighten screwed.
fixture pipe