Instructions / Assembly

2 / 2
12/1/2021
Starting about 1” below the fastener, tightly wrap the connection
With electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit!
5. Connect the black fixture lead wire to the black wire in the outlet box.
Fasten the joined wires as in step 4.
6. Using the two ball nuts to fasten the fixture back plate to the outlet box.
7. inset the glass panel (4pcs) to frame and bend the metal clips on the frame to hold the glass panel in place.
8. Install the lamps (light bulbs).
NOTE: This fixture is rated for 60 watt type B, BA, C or CA lamps
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
9. Install the roof and fasten it with the finial.
10. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(wire nut)