Instructions / Assembly
7
Installation (continued)
6
Installation (continued)
5
Securing the canopy
Care and cleaning
Troubleshooting
The xture will not light.
Problem Possible cause Solution
The power is off.
The circuit breaker is off.
Ensure the power supply is On.
Ensure the circuit breaker is in the On position.
The fuse blows or the circuit breaker
trips when the light is turned on.
The wires are crossed or the power wire
is grounding out.
Check the wire connections.Contact a qualied
electrician or call the Customer Service Team at
1-800-986-3460.
□ Clean the xture with a soft,dry cloth.
□ Do not use any cleaners with chemicals,solvents or hash abrasives.
CAUTION: Before attempting to clean the xture,disconnect the
power to the xture by turning the breaker off or removing the fuse
from the fuse box.
4
Securing the pole
□ Screw the pole (A) onto the xture (B).
□ Tighten ring (DD) onto screw collar loop (CC) to secure
canopy (FF) over cross bar (AA).
□ Open the bottom section of the chain (EE) and attach it to the
pole (A).
I I
B
A
6
Installing the bulbs
□ Screw the bulbs (I I) into the sockets.
NOTE: For bulb replacement, use 40-watt max. medium
base bulbs or medium base CFL equivalent bulbs.
AA
CC
FF
DD
EE
A