Technologies Ethernet Port Start-Up Guide

FieldServer FS-X25 Start-Up Guide Page 7 of 12
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: [phone] Fax: [phone] Toll Free: [phone] email: [e-mail]
3.1.2 DB-9 Pinouts for RS-485 Connection
Four Wire (full duplex multidrop)
Two Wire (1/2 duplex)
Note: The flow signals, RTS and CTS, should be connected as per diagram when unused to prevent loss of
performance on the FieldServer.
For users who do not wish to construct their own connector, we recommend using a DB-9 to screw block
connector which can be purchased from L-Com, Inc.
Item #: DGB9FT Ph: 1-800-341-5266 http://www.l-com.com/item.aspx?id=8141
3.2 Ethernet Connection
The FS-X25 Ethernet port automatically senses an uplink connection, and may therefore be connected to a PC or a
hub/switch using either a crossover cable (not supplied) or a direct Ethernet cable (supplied).
Figure 2: Ethernet Connection port