User Guide

FS-8704-16 Omron FINS Manual Page 31 of 37
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: [phone] Fax: [phone] Toll_Free: 888-509-1970 email: [e-mail]
ELEMENT
NUMBER
CONTENTS DESCRIPTION
1
1
2
3
CPU Status
9
1= Stop
2= Standby (waiting for signal from another
Device)
3= Run
2
1
2
3
CPU Mode
1= PROGRAM
2= MONITOR
3= RUN
3 1/0 1: Memory Error
4 1/0 1: I/O Bus Error
5 1/0 1:Duplication Error
6 1/0 1:Fatal Inner Board Error
7 1/0 1:I/O Point overflow
8 1/0 1:I/O Setting Error
9 1/0 1:Program Error
10 1/0 1:Cycle Time Over
11 0 -
12 1/0 1:FALS Error
13-18 0 -
19 1/0 1:FAL Error
20 Unknown Reserved for System
21 1/0 1:Interrupt Task Error
22 1/0 1:Basic I/O Unit Error
23 Unknown Reserved for System
24 1/0 1:PLC Setup Error
25 1/0 1:I/O Verification Error
26 1/0 1:Inner Board Error
27 1/0 1:CPU Bus Unit Error
28 1/0 1:Special I/O Unit Error
29 1/0 1:Sysmac Bus Error
30 1/0 1:Battery Error
31 1/0 1:CPU Bus Unit Setting Error
32 1/0 1:Special I/O Unit-Setting Error
33-34 Unknown Reserved for System
35-42 0 -
9
PLC Value Driver Value Meaning
0x00 1 Stop
0x80 2 Standby
0x01 3 Run
Note: During testing it has been found that the PLC Value corresponds with this book value. Hence the Driver
stores or sends any other value as it is. User has to do some experiment on it.