User Guide
FS-8700-86 Carrier DataPort Page 16 of 32
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
Error Conditions Force Conditions
Conditions
A
B
C
D
E
F
No Force 0
1
2
3
4
5
Fire 16
17
18
19
20
21
Safety 32
33
34
35
36
37
Service Tool 48
49
50
51
52
53
Supervisor 64
65
66
67
68
69
Monitor 80
81
82
83
84
85
Minimum-off 96
97
98
99
100
101
Control 112
113
114
115
116
117
BEST 128
129
130
131
132
133
Temp Override 144
145
146
147
148
149
Loadshed 160
161
162
163
164
165
Error Conditions:
A no error
B hardware or communications error
C software error
D low alarm limit exceeded (analog point),or point in alarm (discrete point)
E high alarm limit exceeded
F unconfigured point (VVT Gateway only)
Force Conditions:
No Force
Fire forced by fire alarm equipment
Safety forced by internal safety override
Service Tool forced by CCN Service Tool
Supervisor forced by local Building Supervisor
Monitor forced by remote Building Supervisor
Minimum-off forced by minimum off time requirement
Control forced by System Software Option
BEST forced by BEST program
Temp Override forced by temperature override
Loadshed forced by Loadshed System Software Option
Appendix A.2. Field / Variable Names
A list of variable names vs. table names vs. equipment types is not provided in this manual. The
reasons for this are that they are not all available to us they can be configured in some devices using
software provided by the Carrier Corporation.
Consult the points list with the literature provided with each type of equipment from Carrier to obtain
variable names. Alternately use the software provided by Carrier to browse the network and
determine the table and variable names.
This driver may also be used to obtain a list of variable names for a given table. On the following
pages are sample Map Descriptors which may be included in the configuration to help obtain this
information. FieldServer recommends that if these Map Descriptors are used to obtain variable name
information, they should be removed from the final configuration as they will consume resource and
processing time.