Technologies Computer Driver Instruction Manual

FS-8700-41 Simplex 4100 Driver Manual Page 40 of 58
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: [phone] Fax: [phone] Toll_Free: 888-509-1970 email: [e-mail]
Array Position Attribute Value Filled In
5
Note
0 Not Defined 10 1 !
1 PRIMARY STATUS 14 (Normal) 1 #
2 PHYSICAL STATE ~
3 RAW STATE
4 ACTIVE STATE
5 ARMED STATE
6 ENABLED STATE 11 (Enabled) 1
7 UNVERIFIED 0 1
8 CURRENT DEVICE 4 (Correct Device) 1
9 DEVICE 12 (On_Line) 1
10 TEST STATE 3 (Self test normal) 1
11 PRESENT SENSITIVITY SELECTED
14 AVERAGE
17 VALUE 0 1
18 -41 1
19 *
20 PEAK 0 1
21 -41 1
22 *
23 TROUBLE THRESHOLD 6 (Range Normal) 1
24 OUTPUT STATE
25 OUTPUT STATUS
26 DETECTOR SOUNDER
27 ALARM TEMPERATURE SELECTED= 135 1
30 DETECTOR RELAY
Notes:
! The value 10 represents the count of the number of attributes that were extracted from
the response. It is not equal to the number of array locations filled in because some
attributes (e.g. Value) result in more than one array location being updated.
~ The un-filled-in locations are not updated by the driver when this response is analysed
because the attributes corresponding to these locations were not reported in the
response to the query.
* Room for up two three numbers for attributes like value, peak but in this case only two
values are relevant for this device.
5
Locations marked with a 1 are updated when the driver analyses this response