Technologies Computer Driver Instruction Manual
FS-8700-41 Simplex 4100 Driver Manual Page 29 of 58
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldserver.com
• The driver stores in the first array location the number of response lines which resulted
in attribute data being stored. This information can be used for trouble shooting.
The following table reports the attributes that the driver recognizes. This list may be
extended by changing the configuration. If, for example, the attribute ‘ENABLED STATE’ is
recognized then the state of this attribute will be stored at array location 6.
Attribute Array Position
Method
Not Defined 0
1
PRIMARY STATUS 1
1
PHYSICAL STATE 2
1
RAW STATE 3
1
ACTIVE STATE 4
1
ARMED STATE 5
1
ENABLED STATE 6
1
UNVERIFIED 7
2
CURRENT DEVICE 8
1
DEVICE 9
1
TEST STATE 10
1
PRESENT SENSITIVITY SELECTED= 11
2
PRESENT SENSITIVITY SELECTED = 11
2
AVERAGE VALUE = 14
3
AVERAGE VALUE= 14
3
AVERAGE = 14
2
AVERAGE= 14
2
AVERAGE 14
2
VALUE = 17
2
VALUE= 17
2
PEAK= 20
2
PEAK = 20
2
TROUBLE THRESHOLD 23
1
OUTPUT STATE 24
1
OUTPUT STATUS 25
1
DETECTOR SOUNDER 26
1
ALARM TEMPERATURE SELECTED= 27
2
DETECTOR RELAY 30
1
TOTAL NUMBER OF TROUBLES 31
2
NODE MISSING 32
1
VERSION CONTROL 33
1
NODE INITIALIZATION IN PROGRESS 34
1
SIMPLEX SERVICE MODE 35
1
EARTH GROUND 36
1
AC POWER 37
1
BATTERY LOW/DISCHARGED 38
1
BATTERY CHARGE 39
1
SYSTEM PSEUDO STATUS 40
1
NETWORK CARD STATUS 41
1
CARD TROUBLE STATUS 42
1
MISCELLANEOUS STATUS 43
1
RELAY STATUS 44
1
PRIORITY 45
2