Technologies Computer Driver Instruction Manual

FS-8700-41 Simplex 4100 Driver Manual Page 23 of 58
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: [phone] Fax: [phone] Toll_Free: 888-509-1970 email: [e-mail]
Keyword Description Function
ClearAll
Map Descriptor’s which use this function do two things;
Firstly, they register a c-p-s with the driver.
Secondly they define a Data Array name and element
range that must be set to zero when the ClearAll function is
activated.
Up to 4 c-p-s’s may be registered per FieldServer. These
registered points are monitored each time a Clist response
is obtained as well as each time the panel sends an
unsolicited Xpoint message with a state change. If one of
these messages reports a ‘U1’ state for a registered point
then the driver processes all ‘ClearAll’ Map Descriptor’s
and sets all the associated array values to zero.
An example of the use of ClearAll is provided in section
6.12 example 9.
Passive
Specify c-p-s in the
Map Descriptor (but
read the notes on the
left)
Warm_Start
Generates a warm restart message.
Used to test the driver.
Used for simulation
only.
Cold_Start Generates a cold restart message. Used to test the driver.
Used for simulation
only.