User Guide

FS-8700-21 LonWorks Manual Page 8 of 62
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: [phone] Fax: [phone] Toll Free: [phone] email: [e-mail]
4.2 Neuron ID
The driver prints the Neuron ID on the Driver Message Screen as its starts. On FS-B2011 and FS-B4011 FieldServers it is
possible to print the Neuron ID on the Error Screen at any time by pushing the Service Button on the side of the FieldServer.
On all platforms, the driver can store the Neuron ID in a Data Array so that it can be read by a Client node – Refer also to
Appendix C.3.
4.3 Lon LED’s
The location of the Lon LED varies between FieldServer’s. Please consult the Start-up guide for the FieldServer in question.
Lon LED is consistent with the table below for all FieldServers.
Explicit
Implicit – Not Commissioned
Implicit – Commissioned
Off
Flashing
Off
4.4 The LonWorks Adapter Card (FS-X40 only)
4.4.1 Port Address Switch
The LonWorks driver has been configured to access the LonWorks card at ISA port address 340 hex. This is the default setting
for the card, and the DIP switches must not be modified. The DIP switch setting on the card is as follows:
Switch
Setting
1
ON
2
ON
3
OFF
4
ON
5
OFF
6
OFF
7
OFF
8
OFF
Lon LED