User Guide

FS-8700-123_MetOne Particle Counter by Hach Ultra Analytics Manual Page 22 of 26
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: [phone] Fax: [phone] Toll_Free: 888-509-1970 email: [e-mail]
Message Description
MET1:#07 Err. Cant find DA=%s
to get Mode.
MET1:#07b Err. Cant find DA=%s
to set Mode.
MET1:#07c Err. Cant find DA=%s
to get current record.
MET1:#07d Err. Cant find DA=%s
to store times.
Printed by the Server side of the driver. The Server cant
find the specified DA which will be used to store incoming
data or from which data will be extracted to form a
response.
3
MET1:#08a Err. Invalid time
string=%s
MET1:#08b Err. Invalid time
string=%s
Printed by the Server side of the driver. See notes for #4.
MET1:#09a Err.
Met1_Function=%d is unknown.
MD=%s
The reported MD has a Met1 function not recognized by
the driver. This should never happen. Take a log and send
a copy of the log and your configuration to Tech Support.
The FieldServer web site provide tools and instructions for
taking logs
Met1:#10 FYI. No place to store
label data. Label=%s MD=%s
This messages is printed a maximum of 15 times and then
suppressed.
Where the label method is being used to store data. (See
section 4.13) then this message is printed if the driver can’t
find an Map Descriptor with a label which matches the
reported label found in the message from the field device.
The message is printed simply to alert users to what count
labels are being returned. Passive Map Descriptors can
be created to store the reported data, or the message
could be ignored.
MET1:#11a Err. Diagnostic 6
MET1:#11b Err. Diagnostic 1
MET1:#11c Err. Diagnostic 4
MET1:#11d Err. Diagnostic 2
MET1:#11e Err. Diagnostic 7
Printed by the Server side of the driver. These are printed
when internal diagnostics are triggered. This should never
be the case in an operational system. Take a log and
contact Tech Support. The FieldServer web site provide
tools and instructions for taking logs
MET1:#12 FYI. Use an Array
called <%s> to expose diagnostic
info.
This message can be ignored. For more information read
Appendix A.2
3
Update the configuration file, download the modified configuration file and reset the FieldServer for the
changes to take effect.