User Guide

FS-8700-123 MetOne Particle Counter Serial Driver Manual Page 11 of 26
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: [phone] Fax: [phone] Toll_Free: 888-509-1970 email: [e-mail]
4.6. Map Descriptor Example 2 – Write Hold (or Sample) Times to a Device.
In this example the driver writes the hold time to the field device. The time is specified in seconds. A max of 23 hours 59 minutes and 59 seconds can be specified. To write Sample Times simply change the Met1_Function to ‘Sample Time. The driver extracts
the time from the response and stores the hours at the specified offset, the minutes in the next Data Array location and the seconds in the 3
rd
location.
// Client Side Map Descriptors Map_Descriptors Map_Descriptor_Name, Data_Array_Name, Data_Array_Offset, Function, Node_Name Met1_Function, Length Write_Time, DA_TIMES, 0, WRBX, MET1, Hold Time , 1
4.7. Map Descriptor Example 3 – Read the operating mode.
In this example the driver reads the operating mode from the field device. The driver stores a single element of data extracted from the response. The driver stores a ‘C’ to indicate the field device is counting, a ‘H’ to indicate the device is holding and an ‘S’ to indicate that it has stopped. If the mode is not recognized the driver store s a ‘?’. If another protocol reads these states from the FieldServer it will probably display the ASCII value corresponding to each mode letter: ‘C’=67 ‘H’=72 and ‘S’=83 // Client Side Map Descriptors Map_Descriptors Map_Descriptor_Name, Data_Array_Name, Data_Array_Offset, Function, Node_Name Met1_Function, Length, Scan_Interval Write_Time, DA_MODE, 0, rdbc, MET1, Mode , 1, 1.0s
The driver will extract the time in seconds from the Data Array specified here and use it to form the command message to the field device.
The location in the Data Array
This function ‘wrbx’ tells the driver to only send the command each time the value found in the specified DA:offset is updated. Update means each time some other protocol writes to this DA:offset
Change this to ‘Sample Time’ to command a sample time or make two Map Descriptors – each with the correct time function.
Tells the FieldServer that one element of the data array is reserved for this Map Descriptor.