Technologies Computer Driver Instruction Manual

FS-8700-114 DeviceNet Master Manual Page 5 of 15
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: [phone] Fax: [phone] Toll Free: [phone] email: [e-mail]
3. Hardware Connections
The FieldServer is connected to the DeviceNet network as shown in the connection drawing below.
Connector Pinouts
Pin Signal Description Wire color
1 V- Negative supply voltage black
2 CAN_L CAN_L Bus line blue
3 SHIELD Cable Shield (bare)
4 CAN_H CAN_H Bus line white
5 V+ Positive Supply Voltage red
3.1. Hardware Connection Tips / Hints
Use the recommended network cable and terminators as specified by the DeviceNet network
organization and/or the manufacturer of your network equipment.
Terminate each end of the DeviceNet network with a 121 Ω resistor
The bus interface shall be supplied with 24DC ± 10% on the Fieldbus connector