Technologies Computer Driver Instruction Manual

FS-8700-112 FCI 7100 Series Driver Manual Page 21 of 24
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: [phone] Fax: [phone] Toll_Free: 888-509-1970 email: [e-mail]
Message Description
FCI7100:#28 Err. Invalid Sensor number.
Expected 1..99
FCI7100:#29 Err. Invalid Zone number. Expected
1..255
FCI7100:#30 Err. Invalid Relay number. Expected
1..255
Correct the configuration file.
4
FCI7100:#31 Err. Point Type Invalid.
Valid Point Types are listed in Section
4.4.2
4
FCI7100:#32 Err. No MD Length. Default to 1
You must specify the 'length' of each Map
Descriptor. Refer to Section 4.4.2
44
FCI7100:#33 Err. Driver cant poll or write.
The driver can only listen passively for
message from the panel. Remove any
active Map Descriptors from the
configuration file.
FCI7100:#36 Err. Too Short. Bytes=%d , conn-
>ux_iptr"
An event message is less than 80 bytes
long. If this error is repeated often it is
possible that a FCI firmware update as
made the driver unusable. Take a log and
contact tech support.
4
Correct the configuration file, download to the FieldServer and restart the FieldServer for the
changes to take effect.