Product Manual

Page of 14

SOIL COVER PLATE (Figure 5)

1. The soil cover plate is located at the end of the seeder. There are 2 sets of springs on each

plate that add down pressure.

2. This can be removed if not needed.

Adjustment Before Each Use

1. Adjust the sowing depth and level of the Seeder by using the 3-point link top on your tractor.

2. Adjust coulters by loosening the u-bolts mounted on the planter main frame. Make sure

distance between each opener is the same. All 10 coulters are pre-mounted on this seeder.

3. Check all 4 chains and sprockets on both side of the seeder.

4. Adjust the seeding/fertilizing rate according to previous instructions.

Maintenance

1. Lubricate each chain sprocket, axis and all friction parts every four working hours. Do NOT

lubricate on the chain and disc directly.

2. Check all bolts. Tighten before and/or after each use.

3. Clean and check after each use.

Maintain your seeder. It is recommended that the general condition of any seeder be examined

before it is used. Keep your seeder in good repair by adopting a program of conscientious repair

and maintenance. If any abnormal vibrations or noise occurs, have the problem corrected before

further use. Have necessary repairs made by qualified service personnel.

Cover Plate

Spring Kit