Product Manual

Page of 28
7
350lb SPREADER ASSEMBLY INSTRUCTION
Step 1
Note: Round head of bolts should be inside of
the hopper and the nuts should be to the
outside of the hopper.
1) Assemble the 4 panels with bolts and nuts according to the drawing.
2) Assemble the Hopper Bottom Plate with bolts and nuts according to the drawing.
3) Assemble the 4 Corner Caps with bolts and nuts, then tighten all the bolts and nuts.
4) After assembling the hopper, turn the hopper so that the opening is down
for the next assembly steps.
Big Round Head Bolt
1/4” x 1/2”
Hex Flange Nut
1/4”
Hopper Side Panel
Hopper Front Panel
Corner Cap
Big Round Head Bolt
1/4” x 1/2”
Hopper Side Panel
Hopper Bottom
Plate Assembly
*Make sure these 2 labels are
matched by each other when the
user is assembling this part
Hex Flange Nut
1/4”
Hex Flange Nut
1/4”
Hopper Rear
Panel