Product Manual

Page of 11

Step 1: Attach the Center Connecting Collar (#12) to the Crossbar A (#14) at hole

position H using the Hex Bolt M8 x 50 (#11) and Lock Nut M8 (# 6). Attach the Spring

Tines to the Crossbar A at position F, G, J and K using Carriage Bolts M10 x 60 (#9)

and Lock Nuts M10 (#10). Attach the Outside Connecting Collar (#4) between position

A and B using Flat Washers (#3) and Cotter Pins (#2) on each side of the Outside

Connecting Collar; attach another Outside Connecting Collar (#4) between position C

and D in the same way. Install the rings of the Chain (#1) on each side of the Crossbar

A. Attach the Spring Tines to the Crossbar A at position E and M using Carriage Bolts

M10 x 60 (#9) and Lock Nuts M10 (#10).

Note: Position Crossbar A so the A marking on the Crossbar A is near position E

side, standing behind drag facing direction of travel, marking would be on the left

side.