Submittal Sheet

www.ﬁeldcontrols.com

Please retain these instructions after installation.

This device MUST be installed by a qualiﬁed agency in accordance with the manufacturer's installation instructions. The deﬁnition of

a qualiﬁed agency is: any individual, ﬁrm, corporation or company which either in person or through a representative is engaged

in, and is responsible for, the installation and operation of HVAC appliances, who is experienced in such work, familiar with all the

precautions required, and has complied with all the requirements of the authority having jurisdiction.

READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION.

Installation Date:

Installed By: Phone:

120 VOLT RELAY KIT

Model: RJR-6

This device MUST be installed by a qualiﬁed installer in accordance

with the manufacturer’s installation instructions. Wiring MUST be in

accordance with the National Electrical Code and applicable local codes.

ITEMS SUPPLIED WITH THIS KIT

1- 120 Volt Relay

1- Relay Base

2- #8 Sheet Metal Screw

2- 5" Black Wire Leads

2- 5" Blue Wire Leads

1- Retaining Wire

PAGE 1
20 VOLT RELAY KIT Model: RJR-6 This device MUST be installed by a qualified installer in accordance with the manufacturer’s installation instructions. Wiring MUST be in accordance with the National Electrical Code and applicable local codes. ITEMS SUPPLIED WITH THIS KIT 112221- 120 Volt Relay Relay Base #8 Sheet Metal Screw 5" Black Wire Leads 5" Blue Wire Leads Retaining Wire READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION.
PAGE 2
INSTALLATION CAUTION: Disconnect electrical power when wiring relay. 1. Remove square knockout in side of power venter, draft inducer, or Control Kit electrical box. 2. Install wires into relay terminal base. Connect the two (2) blue wires to the terminals marked "A" and "B"; and the two (2) black wires to the terminals "5" and "7". (See Figure 1) Check terminals before installing relay base into electrical box to assure that the wires are connected properly. 3.
PAGE 3
Diagram A Diagram B page 3
PAGE 4
LIMITED WARRANTY Field Controls, LLC (“Company”) warrants that its products shall be free from defects in material and workmanship under normal use for the limited period indicated, from the date of manufacture, subject to the provisions 1-8 below. Eighteen (18) months All Field Controls Products (except for those listed below as 5 years or 90 days). Five (5) years Field Controls Direct Vent Systems (FDVS), Field Oil Vent Kits (FOVP), and ComboVents (CV).