Submittal Sheet

PAGE 1
— 4 Hea Controls Company Sous Nu saber Baa Bran Notes. 2300 Alpert Road Kingston, HC 20601 MODEL PP-4: THERMAL POST PURGE KIT This device MUST be installed by a qualified installer in accordance with the manufacturer's installation instructions. Wiring MUST be in accordance with the National Electrical Code and applicable local codes.
PAGE 2
SWITCH INSTALLATION: pierce a 1/4" dia. hole into the vent pipe between the barometric draft control and the appliance for Oil Sired Systems and Gas Fired Systems without draft hoods (See Figure 1). Mount alter draft hoods for Cas Fired Systems (See Figure 2). Secure switch to vent pipe using the two (2) sheet metal screws provided. WIRING: Wire in accordance with National Electrical Code and applicable local codes.