Submittal Sheet

0.92”
(24 mm)
2.87”
(73 mm)
3.52”
(90 mm)
1.28”
(33 mm)
2.34”
(60 mm)
2.15”
(55 mm)
2.0”
(51 mm)
0.52”
(13 mm)
0.68”
(17 mm)
2.0”
(51 mm)
SPECIFICATIONS
CORE: Split Type
AMPERAGE RANGE: 0.15 - 200A @ 5°F - 140°F
OUTPUT TYPE: N.O., Solid State
OUTPUT RANGE: 1.0A Max. @ 30V AC/DC
HUMIDITY RANGE: 0-95% NON-CONDENSING
Monitor on/off status of blower motor to:
Provide fan proving for S2000 / S2020 Steam Humidifier.
Operate Spring type Damper for Fresh Air.
Also:
Monitor on/off status of various electrical loads.
Monitor direct drive units, exhaust fans and other fixed loads.
This product is not intended for life or safety
applications.
This product is not intended for installation in
hazardous or classified locations.
Installing sensors in an energized motor
control center or on any energized conductor
can be hazardous.
Read instructions thoroughly prior to
installation.
Disconnect and lock-out all power sources
during installation and service. Applications
shown are suggested means of installing
sensors, but it is the responsibility of the
installer to ensure that the installation is in
compliance with all national and local codes.
Installation should be attempted only by
individuals familiar with codes, standards, and
proper safety procedures for high-voltage
installations.
!
Model APD
Current Sensing Switch
SUBMITTAL SHEET
385 Hwy. 33 Englishtown, NJ 07726
Ph: 800-446-3110 - Fx: 732-446-5362
CONTROLS INC.
Excellence Without Compromise
P/N 090377A0122 REV. C Copyright © EWC Controls 2006 All Rights Reserved
E
W
C
APPLICATIONS
FEATURES
Split core for easy installation. No need to rewire High-Voltage.
Mounting bracket provides installation flexibility.
Low 0.15 Amp Trip Point.
100% solid-state, no moving parts to fail.
Forced Air Zone Controls
P/N 090377A0122 REV. D 10/2011 Copyright © 2011, Field Controls Inc., All Rights Reserved
Field Controls Inc. 2630 Airport Road Kinston, NC 28504 PH: 252.522.3031 FAX: [phone]