Submittal Sheet

AIR BOOSTER

Model: AB-2

The Air Booster is designed to increase the flow of heated air or cooled air in

branch ducts of a heating and central air conditioning system. The Air Booster, can

also be used to improve the air flow of a gravity warm air furnace.

The Air Booster should be installed in branch ducts serving individual rooms, where

proper air flows can not be achieved.

Note: Installer must supply junction box.

PAGE 1
AIR BOOSTER Model: AB-2 The Air Booster is designed to increase the flow of heated air or cooled air in branch ducts of a heating and central air conditioning system. The Air Booster, can also be used to improve the air flow of a gravity warm air furnace. The Air Booster should be installed in branch ducts serving individual rooms, where proper air flows can not be achieved. Note: Installer must supply junction box.
PAGE 2
INSTALLATION The Air Booster is not designed for installation in the main air supply ducts. Locating the Air Booster near the outlet end of a problem branch duct will provide the best performance. The Air Booster is designed to operate in round ducts 6-inches in diameter or larger and rectangular ducts 6-inches wide by 6-inches deep or larger. Figure 1A Figure 1B CAUTION: Do not install the Air Booster where the air temperature o within the duct exceed 180 F.
PAGE 3
UNIT WIRING INSTRUCTIONS ELECTRICAL DATA VOLTS AMPS HZ WATTS RPM THERMAL OR IMPEDANCE PROTECTION 120 VAC .60 60 35 3000 YES A permanent wiring method must be used for power connection. It is recommended that a minimum size of 14 AWG wire o o for electrical supply connections and wiring should be suitable for 90 C (194 F) temperature. The Air Booster should be wired with an overcurrent protection device (fuse or circuit breaker) rated 15 amperes or less.
PAGE 4
Page 4 P/N 46422800 04/02