CLEARWAVE® WATER CONDITIONER MODEL: CW-125 The ClearWave® Water Conditioner is the solution to scale build-up due to hard water. The ClearWave installs easily and virtually eliminates scale build-up in pipes, faucets, and appliances. READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION. Please retain these instructions after installation. Installed By: Phone: www.fieldcontrols.
TABLE OF CONTENTS BEFORE YOU INSTALL Customer Satisfaction & Warranty Registration...............................................................................3 Testing for Hardness and Iron Levels...........................................................................................3-4 OPERATION TIMETABLE..................................................................................................................4 INSTALLATION Where to Install the ClearWave®.......................................
precipitate soap, but they often are in complex forms, frequently with organic constituents, and their role in water hardness may be minimal and difficult to define. In conformity with current practice, total hardness is defined as the sum of the calcium and magnesium concentrations, both expressed as calcium carbonate, in milligrams per liter.” The current practice of determining water hardness is the measurement of the concentration of calcium and magnesium in the water.
OPERATION TIMETABLE The following timetable should be used to evaluate the operation of the ClearWave during the first 90 days. DAY 1: The ClearWave action immediately starts to loosen existing scale in both the hot and cold water systems. One should find soap lathers more easily. DAY 5 AND ONWARDS: Scale begins to break down and come off water heater elements (immersion heaters) and tanks.
Figure 2 Properly wrapping the antennae The antennae wrap around the water pipe on each end of the ClearWave. (See Figure 2) A minimum of seven fully wrapped coils of the antenna wire, with each coil wrapped tightly against the pipe and pressed snugly against each other, is required for best results.
TROUBLESHOOTING Power surges and lock ups Your ClearWave water conditioner is designed to operate continuously, providing years of improved water quality. If your water quality seems to have changed check the items below to determine that your ClearWave unit is functioning correctly. To reset the ClearWave, simply unplug the unit, wait 1 minute and reconnect the power supply.
Q. Can the ClearWave be mounted vertically? A. Yes. It can be mounted horizontally, vertically, even diagonally. It is not affected by orientation. Q. Can the ClearWave be used on plastic pipe? A. Yes. The ClearWave can be used effectively on any type of water pipe; galvanized, copper or plastic. Q. A. Does the ClearWave need to be installed on the pipe? No. If the unit cannot be installed directly on the pipe, then we suggest mounting the unit on the wall and wrapping the antennae around the pipe.
LIMITED WARRANTY Field Controls, LLC (“Company”) warrants that its products shall be free from defects in material and workmanship under normal use for the limited period indicated, from the date of manufacture, subject to the provisions 1-8 below. Eighteen (18) months All Field Controls Products (except for those listed below as 5 years or 90 days). Five (5) years Field Controls Direct Vent Systems (FDVS), Field Oil Vent Kits (FOVP), and ComboVents (CV).
CLEARWAVE® WARRANTY REGISTRATION Please take a minute to fill out and mail this registration form to our customer service department today. Place in stamped envelope and mail to: Field Controls, L.L.C. 2630 Airport Road Kinston, NC 28504 ClearWave® Warranty Registration Name: _ Address: City: State: Phone#: _ Zip Code: Fax#: 1. Do you have iron present in your water? YES NO 2.
Phone: 252.522.3031 • Fax: 252.522.0214 www.fieldcontrols.
