User Guide
Outline of the MD02
FIC MD02 Service Manual 1-19
1.6.4 I/O Device Configuration Sub-Menu
PhoenixBIOS Setup Utility
Main Advanced Security Boo Exit
I/O Device Configuration Item Specific
Serial port A: [Auto] Configure serial
Infrared port: [Enabled] using options:
Mode: [IrDA] [Disabled]
Base I/O address: [2E8 IRQ3] No
configuration,
Parallel port: [Auto]
Mode: [EPP] [Enabled]
User
configuration
Floppy disk controller: [Disabled]
[Auto]
BIOS or OS
chooses
configuration
F1
Help
á
â
Select
Item
-/+ Change
Values
F9
Setup
Defaults
Es
c
Exit
ßà
Select
Menu
Ente
r
Select
4
Sub-
Menu
F10
Save and
Exit
• Serial port
You can select the Enabled, Disabled, or Auto option for enabled or disabled
the port, or automatically sensed by BIOS or OS. If you select Enable, you
also need to set the parameter of Base I/O address and IRQ.
• Infrared port
You can select the Enabled, Disabled, or Auto option for enabled or disabled
the port, or automatically sensed by BIOS or OS. If you select Enable, you
also need to set the IR mode, Base I/O and IRQ for the IR device.
• Mode
This field is for information only as the BIOS displays the IR device type of
this notebook.
• Parallel port
Allows you to select the Enabled, Disabled, or Auto option for enabled or
disabled this port, or automatically sensed by BIOS or OS. If you select
Enable, you also need to set the parameter of Base I/O address.
• Mode
Allows you to select a parallel mode as Uni-directional, EPP or ECP when the
parallel port is configured.
• Floppy disk controller
PDF created with FinePrint pdfFactory trial version http://www.fineprint.com