User Guide

Installation and Upgrade
FIC MD02 Service Manual 2-9
Figure 2-6 Remove CPU
9. Remove CPU and insert the preferred CPU.
10. Use a flat screwdriver to lock CPU.
11. Place back the heat plate and keyboard cover. Boot on the computer, and then
BIOS will automatically detect the type of the CPU which just be installed.
2.3.3 Memory Upgrade Procedure
The notebook computer offers two memory slot using SODIMM (Small Outline Dual
Inline Memory Module) at 128MB, 256MB, 512MB and 1GB DDRRAM. Two memory
slots are found inside the memory compartment. The memory compartment is
located on the underside of your computer inside the memory compartment. With two
memory slots, you can have several combinations up to 2GB.
Using the Memory Slot inside the Memory Compartment
Follow the steps below on how to upgrade the memory modules:
1. Make sure the system is powered off and that no peripheral devices are attached.
2. Turn the system over and locate the screw on the memory compartment.
3. Remove the screw and open the memory compartment. Locate the alignment
notch on the module.
4. Locate the memory module socket. Align the notch with the notch in the socket
connector and insert the module as follows:
−
Hold the SODIMM at a 60-degree angle and align the SODIMM connector
with the socket in the system. Push the connector into the socket.
−
Press down on the edge of the SODIMM until the locking tabs on the
sides snap into place, securing the module.
PDF created with FinePrint pdfFactory trial version http://www.fineprint.com