User Guide

Installation and Upgrade
2-10 FIC MD02 Service Manual
5. To remove a SODIMM, press the locking tabs away from the sides of the module
until the module pops up. Then, remove the SODIMM.
6. Reassemble the notebook components as follows.
−
Put the DIMM door back.
− Replace the screw and turn the system over.
2.3.4 Hard Disk Upgrade Procedure
The notebook provides a built-in hard disk for the primary IDE controller. The HDD is
an industry standard 2.5” IDE disk drive and can be upgraded with another standard
2.5” HDD.
1. Make sure the system is powered off and that no peripheral devices are attached.
2. Remove the four screws.
Figure 2-8 Remove HDD module
3. Remove the HDD module from the base unit.
4. Remove four screws of frame HDD bracket plate.
PDF created with FinePrint pdfFactory trial version http://www.fineprint.com